A.S Engineering

• Sturdiness
• Easy installation
• Anti-corrosive

Fibber glass hand knitted surface having knichrome heating elements. Body made of M.S. sheet duly finished with powder coating with energy regulators. Useful for quick heating which save extraction time.

• Individual built-in solid state electronic controls enables easy regulation of heater, while removing sparking associated with mechanical switching
• Support rods are included (12.7 mm diameter)
• Accommodates round bottom flask capacity from 100 mL to 1000 mL at all positions
• Maximum temperature up to 450 ºC
• Polypropylene top cover with external powder coated aluminum surface for good chemical resistance
• Coiled heating element is suspended within a thermal insulating cartridge to provide maximum heat transfer
• Earth (ground) screen encloses the heater for added safety
• Individual heater cartridges are replaceable
• Pilot light shows power on
• Vented case’s unique air flow ensures the case remains cool to the touch

• Sturdiness
• Easy installation
• Anti-corrosive

Having a definite quality management system and quality assurance, we are making available to our patrons a best quality of Laboratory Hot Plate.

• Rugged and durable construction.
• Outer casing is made up of thick mild steel with duly powder coated, gives long service life with extremely resistant.
• Multilayer insulation with vacuum formed ceramic fibre board with low thermal mass.
• Parallel guided swing aside door design with safety switch.
• Furnace design with powerful heating elements for providing fast heating rate.
• Fast heat up and cool down rates.
• Better Temperature Uniformity.
• Temperature Controller with PID Controllers.
• Power control with Thyristor units for very precise temperature Control, wear-free and noiseless.
• High mechanical durability, short heating cycle and low power consumption.

Introduction

Used to monitor and digest the wastewater influent and effluent, industrial process water, blend of chemicals and more. Primarily used by Pollution Control Labs

The Salt Spray Chamber/corrosive resistant machine are specialized to test the performance of the products for its surfaces of various materials after treatment of corrosive protection by means of painting, coating, galvanizing, anodizing and of lubricant. Salt spray test chambers allows selective and reproducible accelerated corrosion testing complying with the requirements of relevant national and international standards such as DIN, ISO, ASTM, DEF, MIL-STD, etc.

International Test Standards

• ASTM B117
• NSS (Neutral Salt Solution)
• ASS (acetic acid Salt spray)
• SWAAT( sea water acidified Test)
•  CASS (Cupric Acid Salt Spray)
•  Salt Fog testing according to DIN 50021
• Condensed water test According to DIN 50017
• Standard climates as specified by DIN 50015

·        Double walled construction

·        Effective insulation for minimum heat loss 

·        Outer cabinet of mild steel material duly powder coated 

·        Inner body made Ceramic fiber Board

·        Ceramic fiber Board is heated to maintain temperature up to 700°C 

·        Digital Temperature Controller, appropriate heater & insulation selection assure uniformity in all the samples. 

·        Selectable timer up to 120 min/h alarm is provided to set the digestion period.

·        After digestion, analyse the sample with titrimetric method. 

• Hepa Filter: Size and QTY. will depend on the size selected